Dell PowerEdge 2650 Installation Manual

Also see for PowerEdge 2650: Manual Installation guide Install guide Information update Information update

Contents

Dell PowerEdge 2650 Installation Manual Manual pdf 16 page image

1-8 Rack Installation GuideInstalling the Slide Assemblies in the RackNOTE: If the slide assemblies were preinstalled by Dell, you can skip this section.You must allow 2 U (3.5 inches) of vertical space for each system you install in therack.NOTE: The vertical rails of the rack are marked by small indentations in 1-Uincrements (see Figure 1-6).Figure 1-6. One Rack UnitFor more information about requirements for installing components in a Dell rack, seethe Dell Rack Advisor software available on the Dell Web site athttp://support.dell.com.CAUTION: If you are installing more than one system, install the slideassemblies so that the first system is installed in the lowest available posi-tion in the rack.To install the slide assemblies in the rack, perform the following steps:1. Place the front of the template on the vertical rails at the front of the rack whereyou want to install the system.Ensure that the printing on the template identifies the side facing outward as thetemplate front.1 U (1.75 inches)