Dell PowerEdge 4600 Manual
Also see for PowerEdge 4600: Removal guideManualInstallation guideInformation updateInstallation guide
                   | |
Contents
| 
1-10 Rack-to-Tower Conversion Guidew w w . d e l l . c o m | s u p p o r t . d e l l . c o m h Lay the front panel on a smooth work surface with the outside surface facingdown.i Remove the two 6-32 x 0.25-inch hex-head Phillips screws that secure the controlpanel board to the back of the front panel.Set the control panel and screws aside for installation on the tower front panel.Installing the Trim PanelTo install the tower trim panel on the chassis, perform the following steps.NOTE: You may find it convenient to leave the chassis in the rack position (as shownin Figure 1-6) while installing the trim panel.1 Hold the tower trim panel in position with the sides facing up as shown in Figure 1-6.NOTICE: You will need two to four persons to lift the system into position above thetrim panel. One additional person may be needed to separate the trim panel fromchassis obstructions.2 Using two or four persons, lift the system chassis.3 Lower the system chassis into the trim panel (see Figure 1-6).4 After the chassis is lowered into place, align the three holes in the trim panel with thethree holes in the chassis.5 Secure the right side of the trim panel with three 6-32 x 0.25-inch hex-head Phillipsscrews (see Figure 1-6).6 Secure the back of the trim panel with three 6-32 x 0.25-inch hex-head Phillips screws. |
Related manuals for Dell PowerEdge 4600
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine