Dell PowerEdge 6600 Installation Manual

Also see for PowerEdge 6600: Installation guide User guide Notice Specifications Installation and troubleshooting guide

Contents

1-12 Rack-to-Tower Conversion Guidew w w . d e l l . c o m | s u p p o r t . d e l l . c o mInstalling the Trim PanelTo install the tower right-side trim panel on the chassis, perform the following steps:NOTE: You may find it convenient to leave the chassis in the rack position (as shownin Figure 1-7) while installing the right-side trim panel.1 Hold the tower right-side trim panel in position with the sides facing up as shown inFigure 1-7.NOTE: You will need two to four persons to lift the system into position just abovethe right-side trim panel. One additional person may be needed to separate thetrim panel from chassis obstructions.2 Using two or four persons, lift the system chassis using the four handles on the sides.3 Check to see that the slots in the inner surfaces of the trim panel are aligned directlybelow the shoulder screws on the side of the system chassis (see Figure 1-7).4 Lower the system chassis into the right-side trim panel, with the shoulder screwsentering the slots on the inner surfaces of the trim panel.5 After the chassis is lowered into place, move the trim panel forward until it is flushwith the front panel.6 Secure the right-side of the trim panel with three 6-32 x 0.25-inch hex-head Phillipsscrews from the inside of the system chassis (see Figure 1-7).