Getting Started With Your System | 5CAUTION: Restricted Access LocationThis server is intended for installation only in restricted access locations asdefined in Cl. 1.2.7.3 of IEC 60950-1: 2001 where both these conditions apply: Access can only be gained by service persons or by users who have beeninstructed about the reasons for the restrictions applied to the location andabout any precautions that shall be taken. Access is through the use of a tool or lock and key, or other means ofsecurity, and is controlled by the authority responsible for the location.Installation and ConfigurationWARNING: Before performing the following procedure, review and follow thesafety instructions that came with the system.Unpacking the SystemUnpack your system and identify each item.Installing the Tool-Less Rail SolutionWARNING: Whenever you need to lift the system, get others to assist you.To avoid injury, do not attempt to lift the system by yourself.WARNING: The system is not fixed to the rack or mounted on the rails. Toavoid personal injury or damage to the system, you must adequatelysupport the system during installation and removal.WARNING: To avoid a potential electrical shock hazard, a third wire safetygrounding conductor is necessary for the rack installation. The rackequipment must provide sufficient airflow to the system to maintain propercooling.CAUTION: When installing rails in a square-hole rack it is important toensure that the square peg slides through the square holes.