Installing System Components 1093 Route the fan power cable through the adjacent slot in the chassis, andconnect the cable to the FAN1 connector on the system board (seeFigure 6-1).4 Replace the RAID battery and battery carrier, if applicable (see "Installinga RAID Battery" on page 102).5 Close the expansion card cover (see Figure 3-7).6 Replace the system cover (see "Installing the System Cover" on page 67).Removing the System FanCAUTION: Many repairs may only be done by a certified service technician. Youshould only perform troubleshooting and simple repairs as authorized in yourproduct documentation, or as directed by the online or telephone service andsupport team. Damage due to servicing that is not authorized by Dell is not coveredby your warranty. Read and follow the safety instructions that came with theproduct.1 Turn off the system and attached peripherals, and disconnect the systemfrom the electrical outlet and from the peripherals.2 Remove the system cover (see "Removing the System Cover" on page 66).3 Remove the processor airflow shroud (see "Removing the Processor AirflowShroud" on page 70).4 Disconnect the fan’s power cable from the system board (see Figure 6-1).5 Press and hold the fan release tab, then slide the fan towards the bottom ofthe chassis and out of the securing slots.
