Dell PowerEdge M1000e Configuration Manual

Also see for PowerEdge M1000e: Manual Command reference guide Owner's manual Update Getting started guide

Dell PowerEdge M1000e Configuration Manual Manual pdf 41 page image

Configuration Guide 39Before You BeginNetwork InformationYou can configure your I/O switch modules using the CMC, as outlined in"Configuring a Switch Module Network Ethernet Port Using the Web-BasedInterface " on page 39 (the default IP address for the CMC is 192.168.0.120),through the CMC CLI via serial console redirection, direct access to the I/Omodule’s serial port (if supported), or using the I/O module’s default IP address(if supported).Switch ModulesConfiguring a Switch Module Network Ethernet Port Using theWeb-Based InterfaceYou can use the CMC Web-based interface to configure an I/O module’sEthernet port.NOTE: Use this procedure to configure the switch’s out-of-band Ethernet port. Theswitch’s in-band management IP address is configured through the switch’sexternal ports. These two IP addresses must be different, and on differentnetworks.NOTE: To change settings on the I/O module configuration page, you must haveFabric Administrator privileges for the particular Fabric in which the module isinstalled.NOTE: The network IP address set on the I/O module by the CMC is not saved to aconfiguration file. To save the IP address configuration permanently, use theconnect switch-n RACADM command, or use a direct interface to the I/Omodule GUI.NOTE: Do not attempt to configure I/O module network settings for Ethernetpassthrough or Infiniband switches.1 Log in to the CMC’s Web-based interface. See "Logging in to the CMCUsing the Web-Based Interface" on page 25.2 Select I/O Modules in the Chassis menu in the system tree.3 Select the Setup tab. The Configuring I/O Modules Network Settingspage appears.