86 Using the System Setup ProgramSerial Communication ScreenThe blade has a single serial port (COM1) which can be enabled for consoleredirection through the IMC. Table 2-6 lists the options and descriptions forthe information fields that appear on the Serial Communication screen.MAC Address Displays the MAC address for a particular integrated NIC.This field does not have user-selectable settings.Capability Detected Displays the features provided by the hardware keyinstalled in the TOE_KEY socket on the system board.NOTE: Some features may require the installation of anadditional driver.OS Watchdog Timer(Disabled default).If set to Enabled, the operating system will restart thesystem if it locks up, based on the expiration of a timer. Ifset to Disabled, in the event of a system lockup, no timerwill be set and the OS will not restart the system in theevent of a lockup.I/OAT DMA Engine(PowerEdge M600 only.Disabled default).If set to Enabled, the I/O Acceleration Technology featureis enabled for network controllers that support thistechnology.Table 2-6. Serial Communication Screen OptionsOption DescriptionSerial Communication(Off default)Options are On with Console Redirection via COM1, andOff.Failsafe Baud Rate(115200 default)Displays the failsafe baud rate used for console redirectionwhen the baud rate cannot be negotiated automaticallywith the remote terminal.Remote Terminal Type(VT 100/VT 220default)Select either VT 100/VT 220 or ANSI.Redirection After Boot(Enabled default)Enables or disables BIOS console redirection after yoursystem boots to the operating system.Table 2-5. Integrated Devices Screen Options (continued)Option Description
