114 Installing System Components4 Align the front edge of the card with the connector on the system board.See Figure 6-1 for the location of the connector.5 Press the card down until it is fully seated. See Figure 3-18.When the front of the card is fully seated, the plastic standoff tab snapsover the edge of the holder.6 Close the system. See "Closing the System" on page 83.7 Reconnect the system to its electrical outlet and turn the system on,including any attached peripherals.iDRAC6 Enterprise Card (Optional)Removing an iDRAC6 Enterprise CardCAUTION: Many repairs may only be done by a certified service technician.You should only perform troubleshooting and simple repairs as authorized inyour product documentation, or as directed by the online or telephone serviceand support team. Damage due to servicing that is not authorized by Dell isnot covered by your warranty. Read and follow the safety instructions thatcame with the product.1 Turn off the system, including any attached peripherals, and disconnectthe system from the electrical outlet.2 If present, disconnect the Ethernet cable from the iDRAC6 enterprise cardconnector on the system back panel. See Figure 1-4.3 Open the system. See "Opening the System" on page 82.4 Remove the system board shroud. See "Removing the System BoardShroud" on page 109.5 Remove the VFlash media card (if applicable) from the iDRAC6enterprise card. See "Removing a VFlash Media Card" on page 116.6 Pull back slightly on the two tabs at the front edge of the card and gentlylift the front edge of the card off of the retention standoffs.As the card releases from the standoffs, the connector under the carddisengages from the system board connector.7 Slide the card away from the back of the system until the RJ-45 connectoris clear of the back panel, then lift the card out of the system.
