70 Using the System Setup Program and UEFI Boot ManagerEmbedded Server Management ScreenNOTE: This section is applicable to systems with hot-swappable hard drives only.Serial Port Address(Serial Device 1=COM1,Serial Device 2=COM2default)Sets the serial port addresses for the two serial devices.NOTE: Only Serial Device 2 can be used for Serial OverLAN (SOL). To use console redirection by SOL, configurethe same port address for console redirection and theserial device.External Serial Connector(Serial Device1 default)Specifies whether Serial Device 1, Serial Device 2,or Remote Access Device has access to theexternal serial connector.NOTE: Only Serial Device 2 can be used for Serial OverLAN (SOL). To use console redirection by SOL,configure the same port address for console redirectionand the serial device.Failsafe Baud Rate(115200 default)Displays the failsafe baud rate used for consoleredirection. BIOS attempts to determine the baud rateautomatically. This failsafe baud rate is used only if theattempt fails. This rate should not be adjusted.Remote Terminal Type(VT100/VT220 default)Sets the remote console terminal type, eitherVT100/VT220 or ANSI.Redirection After Boot(Enabled default)Enables or disables BIOS console redirection when theoperating system is loaded.Option DescriptionFront Panel LCDOptionsOptions are User Defined String, Model Number, or None.If the LCD Home display is set to anything other than UserDefined String, Model Number, or None, this option in BIOSwill display Advanced. You will not be able to edit this setting inBIOS until it is set back to User Defined String, Model Number,or None through another LCD configuration utility (such as theoptional BMC or iDRAC6 Configuration Utility or LCD panelmenu).User-DefinedLCD StringYou can enter a name or other identifier for the system, to bedisplayed on the LCD module screen.Option Description
