Option DescriptionSet error Select SEL to display LCD error messages in a format that matches the IPMI description in theSEL. This is useful when trying to match an LCD message with an SEL entry.Select Simple to display LCD error messages in a simplified user-friendly description. SeeSystem Error Messages for a list of messages in this format.Set home Select the default information to be displayed on the LCD Home screen. See View Menu to seethe options and option items that can be set as the default on the Home screen.View MenuNOTE: When you select an option in the View menu, you must confirm the option before proceeding to the nextaction.Option DescriptioniDRAC IP Displays the IPv4 or IPv6 addresses for the iDRAC7. Addresses include DNS (Primary andSecondary), Gateway, IP, and Subnet (IPv6 does not have Subnet).MAC Displays the MAC addresses for iDRAC, iSCSI, or Network devices.Name Displays the name of the Host, Model, or User String for the systemNumber Displays the Asset tag or the Service tag for the system.Power Displays the power output of the system in BTU/hr or Watts. The display format can beconfigured in the Set home submenu of the Setup menu.Temperature Displays the temperature of the system in Celsius or Fahrenheit. The display format can beconfigured in the Set home submenu of the Setup menu.Diagnostic IndicatorsThe diagnostic indicators on the system front panel display error status during system startup.NOTE: The diagnostic indicators are not present if the system is equipped with an LCD display.NOTE: The diagnostic indicators are present only on the 10-hard drive system.The following section describes system conditions and possible corrective actions associated with these indicators:Electrical indicatorCondition Corrective ActionThe indicator blinksamber if the systemexperiences anelectrical error (forexample, voltage outof range, or a failedpower supply orvoltage regulator).See the System Event Log or system messages for the specific issue.If it is due to a problem with the power supply, check the LED on thepower supply. Re-seat the power supply by removing and reinstallingit. If the problem persists, see Getting Help.13
