5. power supply handleInstalling a DC power supply unitPrerequisitesWARNING: For equipment using –(48–60) V DC power supplies, a qualified electrician mustperform all connections to DC power and to safety grounds. Do not attempt connecting to DCpower or installing grounds yourself. All electrical wiring must comply with applicable local ornational codes and practices. Damage due to servicing that is not authorized by Dell is notcovered by your warranty. Read and follow all safety instructions that came with the product.Steps1. Verify that both the power supplies are of the same type and have the same maximum output power.NOTE: The maximum output power (shown in watts) is listed on the PSU label.2. If installed, remove the power supply blank.3. Slide the new power supply unit into the chassis until the power supply unit is fully seated and therelease latch snaps into place.NOTE: If you unlatched the cable management arm, relatch it. For information about the cablemanagement arm, see the system’s rack documentation.4. Connect the safety ground wire.5. Install the DC power connector in the power supply unit.CAUTION: When connecting the power wires, secure the wires with the strap to the powersupply handle.6. Connect the wires to a DC power source.NOTE: When installing, hot-swapping, or hot-adding a new power supply, wait for 15 secondsfor the system to recognize the power supply and determine its status. The power-supplystatus indicator turns green to signify that the power supply is functioning properly.System batteryReplacing the system batteryPrerequisites1. Ensure that you read the Safety instructions.2. Follow the procedure listed in Before working inside your system.3. Remove the cooling shroud.WARNING: There is a danger of a new battery exploding if it is incorrectly installed. Replace thebattery only with the same or equivalent type recommended by the manufacturer. For moreinformation, see the safety information that shipped with your system.CAUTION: Many repairs may only be done by a certified service technician. You should onlyperform troubleshooting and simple repairs as authorized in your product documentation, or asdirected by the online or telephone service and support team. Damage due to servicing that isnot authorized by Dell is not covered by your warranty. Read and follow the safety instructionsthat came with the product.105
