• If the problem persists, use another connector on the switch or hub.4. Ensure that the appropriate drivers are installed and the protocols are bound. For more information,see the NIC documentation.5. Enter System Setup and confirm that the NIC ports are enabled on the Integrated Devices screen.6. Ensure that all the NICs, hubs, and switches on the network are set to the same data transmissionspeed and duplex. For more information, see the documentation for each network device.7. Ensure that all network cables are of the proper type and do not exceed the maximum length.Next stepsIf all troubleshooting fails, see Getting Help.Troubleshooting a wet systemPrerequisitesCAUTION: Many repairs may only be done by a certified service technician. You should onlyperform troubleshooting and simple repairs as authorized in your product documentation, or asdirected by the online or telephone service and support team. Damage due to servicing that isnot authorized by Dell is not covered by your warranty. Read and follow the safety instructionsthat came with the product.Steps1. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.2. Remove the system cover.3. Remove the following components from the system:• hard drives• hard drive backplane• USB memory key• hard drive tray• cooling shroud• expansion card risers (if present)• expansion cards• power supply unit(s)• cooling fan assembly (if present)• cooling fans• processor(s) and heat sink(s)• memory modules4. Let the system dry thoroughly for at least 24 hours.5. Reinstall the components you removed in step 3 except the expansion cards.6. Install the system cover.7. Turn on the system and attached peripherals.If the system does not start properly, see Getting Help.8. If the system starts properly, shut down the system, and reinstall all the expansion cards that youremoved.9. Run the appropriate diagnostic test. For more information, see Using System Diagnostics.148