Dell PowerEdge R730xd Deployment Manual

Also see for EMC PowerEdge R640: Installation and service manual Installation and service manual Installation and service manual Manual Hardware installation guide

Dell PowerEdge R730xd Deployment Manual Manual pdf 63 page image

63 Dell EMC Networking with Isilon Front-End Deployment and Best Practices Guide | version 1.0port-channel101 Desg 128.2617 128 1000 FWD 0 AUTO Yesport-channel102 Desg 128.2618 128 1000 FWD 0 AUTO Yes--- Output is truncated ---8.1.9 Show vrrp briefThis command is used to verify that VRRP is correctly configured and both switches in the VLT have thesame virtual address.S4048-Leaf1# show vrrp briefInterface Group Priority Prempt State Version Master addr(s) Virtual addr--------------------------------------------------------------------------------vlan100 IPv4 100 150 true master-state 2 172.16.1.252 172.16.1.2548.2 OS9 Validation commands8.2.1 show ip bgp summaryWhen BGP is configured, this command shows the status of all BGP connections. Each spine has fourneighbors (the four leafs) and each leaf has two neighbors (the two spines). The 2 spine neighbors areshown below.S4048-Leaf3#show ip bgp summaryBGP router identifier 10.0.2.3, local AS number 64703BGP local RIB : Routes to be Added 0, Replaced 0, Withdrawn 016 network entrie(s) using 1216 bytes of memory30 paths using 3240 bytes of memoryBGP-RIB over all using 3270 bytes of memory19 BGP path attribute entrie(s) using 3456 bytes of memory17 BGP AS-PATH entrie(s) using 170 bytes of memory2 neighbor(s) using 16384 bytes of memoryNeighbor AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/Pfx192.168.1.4 64601 28655 128086 0 0 0 3d:19:43:08 14192.168.2.4 64602 128677 128092 0 0 0 3d:19:43:06 148.2.2 show ip route bgpOn switches with BGP configured, this command is used to verify the BGP entries in the Routing InformationBase (RIB). Entries with multiple paths shown are used with ECMP.The first set of routes with a subnet mask of /32 are the IPs configured for router IDs.S4048-Leaf3 has two paths to all other leafs and two paths to Server 1’s network, 172.16.1.0. There is onepath through each spine. If all paths do not appear, make sure the maximum-paths statement in the BGPconfiguration is equal to or greater than the number of spines in the topology.