Removing Memory ModulesWARNING: The memory modules are hot to the touch for some time after the system has been powered down.Allow time for the memory modules to cool before handling them. Handle the memory modules by the card edgesand avoid touching the components on the memory module.CAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.CAUTION: To ensure proper system cooling, memory-module blanks must be installed in any memory socket that isnot occupied. Remove memory-module blanks only if you intend to install memory in those sockets.1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet andperipherals.2. Open the system.3. If applicable, remove the cooling shroud or the processor expansion module.4. Locate the appropriate memory module socket(s).CAUTION: Handle each memory module only on either card edge, making sure not to touch the middle of thememory module.If a memory module blank is installed in the socket, remove it. Retain removed memory-module blank for future use.5. Press down and out on the ejectors on each end of the socket until the memory module pops out of the socket.Figure 17. Removing and Installing a Memory Module or Memory Module Blank1. memory module2. memory-module socket ejectors (2)3. alignment key6. Install memory-module blanks in vacant memory-module socket(s) to ensure proper system cooling.47
