22 About Your SystemCaution!NVRAM_CLR jumperis installed onsystemboard.Please runSETUP.NVRAM_CLR jumper isinstalled in the clearsetting. CMOS has beencleared.Move the NVRAM_CLRjumper to the default position(pins 3 and 5). See Figure 6-1for jumper location. Restartthe system and re-enter theBIOS settings. See "Using theSystem Setup Program andUEFI Boot Manager" onpage 35.CPU set tominimumfrequency.The processor speed maybe intentionally set lowerfor power conservation.If not an intentional setting,check other system messagesfor possible causes.Current boot modeis set to UEFI.Please ensurecompatiblebootable media isavailable. Usethe system setupprogram to changethe boot mode asneeded.The system failed to bootbecause UEFI boot mode isenabled in BIOS and theboot operating system isnon-UEFI.Ensure that the boot mode isset correctly and that theproper bootable media isavailable. See "Using theSystem Setup Program andUEFI Boot Manager" onpage 35.Decreasingavailablememory.Faulty or improperlyinstalled memory modules.Reseat the memory modules.See "Troubleshooting SystemMemory" on page 113.Embedded NICx andNICy:OS NIC=|DISABLED>,ManagementShared NIC=|DISABLED>The operating system NICinterface is set in BIOS.The Management SharedNIC interface is set inmanagement tools.Check the systemmanagement software or theSystem Setup program forNIC settings. If a problem isindicated, see"Troubleshooting a NIC" onpage 107.Message Causes Corrective Actions
