Steps1 Remove the power-switch cable from the chassis clip.2 Remove the screw securing the power switch to the chassis.3 Slide the power switch down to disengage it from the slot and pull out the power switch from the system.Figure 12. Removing the power switchNext steps1 Connect the power-switch cable to the system board.2 Install the bezel3 Install the power switch.4 Follow the procedure listed in the After working inside your system section.Related linksSafety instructionsBefore working inside your systemRemoving the bezelInstalling the bezelInstalling the power switchAfter working inside your systemInstalling the power switchPrerequisitesCAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simplerepairs as authorized in your product documentation, or as directed by the online or telephone service and support team.Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructionsthat are shipped with your product.1 Follow the safety guidelines listed in the Safety instructions section.2 Follow the procedure listed in the Before working inside your system section.3 Keep the Phillips #2 screwdriver ready.Steps1 Insert and route the power-switch cable through the chassis clip.2 Slide the power switch through the slot on the front of the system and secure it to the system.3 Connect the power-switch cable to the power-switch connector on the system board.46 Installing and removing system components
