114 Installing System Components6 Press down and out on the ejectors on each end of the socket until thememory module pops out of the socket. See Figure 3-17.Handle each memory module only on either card edge, making sure not totouch the middle of the memory module.NOTE: If you are not replacing the memory module, insert a memory moduleblank in the socket.7 Replace the cooling shroud. See "Installing the Cooling Shroud" onpage 89.8 Replace the expansion card stabilizer. "Installing the Expansion CardStabilizer" on page 87.9 Close the system. See "Closing the System" on page 86.10 Place the system upright on a flat surface.11 Reattach any peripherals and connect the system to an electrical outlet.12 Turn on the system and attached peripherals.Expansion CardsExpansion Card Installation GuidelinesYour system supports five PCIe Generation 2 expansion cards. To identify theexpansion slots see Figure 6-1.• The expansion slots support one full-length, and four half-length cards.• The expansion-card slot is not hot-swappable.CAUTION: To ensure proper cooling, only one of the two expansion cardscan have a power consumption of greater than 15 W (up to 25 W maximum),not including the integrated storage controller.• Table 3-3 provides a guide for installing expansion cards to ensure propercooling and mechanical fit. The expansion cards with the highest priorityshould be installed first using the slot priority indicated. All otherexpansion cards should be installed in card priority and slot priority order.
