Installing System Components 1213 Pull back slightly on the retention standoff tab at the front edge of thecard and gently lift the card off the retention standoff. See Figure 3-19.As the holder releases from the standoff, the connector under the carddisengages from the system board connector.4 Angle the card so that the notch on the card slips through the clipon the system board.5 Close the system. See "Closing the System" on page 86.6 Place the system upright on a flat surface.7 Reattach any peripherals and connect the system to an electrical outlet.8 Turn on the system and attached peripherals.iDRAC6 Enterprise Card (Optional)Installing an iDRAC6 Enterprise CardCAUTION: Many repairs may only be done by a certified service technician.You should only perform troubleshooting and simple repairs as authorized inyour product documentation, or as directed by the online or telephone serviceand support team. Damage due to servicing that is not authorized by Dell is notcovered by your warranty. Read and follow the safety instructions that camewith the product.1 Turn off the system, including any attached peripherals, and disconnectthe system from the electrical outlet.2 Open the system. See "Opening the System" on page 85.3 Remove the expansion card stabilizer. See "Removing the Expansion CardStabilizer" on page 87.4 Remove the cooling shroud. See "Removing the Cooling Shroud" onpage 88.5 Remove the plastic filler plug for the iDRAC6 Enterprise port fromthe system back panel.6 Angle the card so that the RJ-45 connector fits through the back-panelopening. See Figure 3-20.7 Align the front edge of the card with the two front plastic retentionstandoffs next to the iDRAC6 Enterprise connector on the system board,and lower the card into place. See Figure 3-20.Downloaded from www.Manualslib.com manuals search engine
