Troubleshooting 31BIOS Error Messages• Message: Press to enable BIOSDescription: When the BIOS is disabled, you are given the option toenable it by entering the Configuration Utility. You can change the settingto Enabled in the Configuration Utility.• Message: Adapter configuration may have changed,reconfiguration is recommended!Press CTRL-C to run Dell 6 Gbps SAS HBA ConfigurationUtility…Description: Start the Configuration Utility and confirm theconfiguration of the 6 Gbps SAS HBA or Internal Tape Adapter controller.• Message: Initializing...Description: This message is displayed while the BIOS is waiting toinitialize.• Message: SAS discovery errorDescription: Indicates that there is a discovery error reported by thefirmware and may be accompanied by more such messages. Enter theConfiguration Utility to investigate.• Message: Device not available at HBA n, HDL n, LUNDescription: Device may not be ready at this time. The device will beretried. If the problem persists, restart your system.• Message: ERROR! Device is not responding to ReadCapacityDescription: The device does not respond to a read capacity command.Contact Dell.• Message: Failed to add device, too many devices!Description: Cannot allocate resources for additional devices.• Message: ERROR! Adapter Malfunctioning!Description: The adapter did not initialize properly. There may be aproblem with the adapter configuration. Reload the BIOS configuration.Start the Configuration Utility again and see if the issue persists.
