17Getting Started |3 Record the IP address.4 To exit, type 0 and press Enter; then type 0 and press Enter again. The card is now operational.Configuring the Network Without a DHCP ServerTo set the network configuration manually:1 From the main menu, type 2 and press Enter. Type 2 and press Enter again to modify the networksettings. The Network Settings menu displays (see Figure 11).NOTE: You cannot configure the IPv6 address through the serial link. The IPv6 address is provided by the cardor by the IPv6 DHCP server (if an IPv6 DHCP server is available on the network). See “Network Settings” onpage 49 to enable the IPv6 feature and configure IPv6 settings.-------------------------------------------------------------Network settings-------------------------------------------------------------1 : Read Network settings2 : Modify Network settings3 : Set Ethernet speed0 : Exit-------------------------------------------------------------For each of the following questions, you can press to selectthe value shown in braces, or you can enter a new value.Should this target obtain IP settings from the network?[N] NStatic IP address [166.99.1.2]? 166.99.21.21Static IP address is 166.99.21.21Subnet Mask IP address [255.255.248.0]? 255.255.255.0Subnet Mask IP address is 255.255.255.0Gateway address IP address [166.99.17.1]? 166.99.17.1Gateway address IP address is 166.99.17.1Wait while your new configuration is saved.Reset the card to enable the new configuration.Figure 11. Modifying the Network Settings2 Follow the instructions and enter the static IP parameters (IPv4 only).Wait until Done displays, indicating that the IP parameters have been saved.3 To exit, type 0 and press Enter.4 Type 1 and press Enter, and then type 2 and press Enter to restart.The card restarts with the new IP settings in approximately one minute.