Dell PowerVault MD3060e Installation Manual

Also see for PowerVault MD3060e Series: Manual Installation and configuration guide Hardware and software guide Getting started guide Information update

Contents

Dell PowerVault MD3060e Installation Manual Manual pdf 10 page image

1. Go to the directory where SMI-S Provider is installed.The default install directories are:– <%Program Files%>/Dell/pegasus/provider/array for Windows.– /opt/dell/pegasus/array for Linux.2. Edit providerTraceLog.properties file in a text file editor, by following the steps below:a) Remove the pound sign (#) from the lines containing File, Level, and Events.b) Edit the file name in the field File.This file contains the trace messages.3. Save providerTraceLog.properties file and exit the text file editor.4. Stop and start the OpenPegasus CIM server.See Starting And Stopping The OpenPegasus CIM Server.Troubleshooting The SMI-S ProviderThe following table lists some of the common issues and their resolutions.Table 2. Common Issues and ResolutionsIssue Recommended ActionThe following message is displayed if SMI-S Provider isinstalled on a system for the first time:cimserver not started: Bind failed:Failed to bind socketon port 5989: Address already in use(error code 125).This issue occurs when there is a port conflict. To resolvethe conflict, remove the application that is using the portor select a different port.To select a different port:1. Stop the CIM server.2. Set the new ports using the following commands:cimconfig -s httpPort= PORT> -pimconfig -s httpsPort=-p3. Start the CIM server.CIMOM default port in use is not reported in the MicrosoftWindows operating system.In Windows, if the default ports 5988 and 5989 are alreadyin use during the SMI-S Provider installation, no messageis displayed to confirm that the ports are in use.To resolve the conflict:1. Edit the cimserver_current.conf andcimserver_planned.conf files.2. Specify the open ports.3. Start the CIM server.Service Location Protocol Service Agents (SLP SA) inmulti-CIMOM environments.Only one SLP SA per individual server can be activebecause SAs require the fixed port 477.NOTE: If the operation started on a non-standard port,dynamic SLP discovery of the CIM service is notpossible.The CIM client methods fail due to authentication error:Return Code -4 During installation, you do not run into any issues with thestorage array password because the SMI-S Provider doesnot yet have information about the storage arrays tomanage. However, after you add the storage arrays, a10

/ 11

Related manuals for Dell PowerVault MD3060e Series