Dell PowerVault MD3200 Deployment Manual

Also see for PowerVault MD3200 Series: Manual Update Rack Installation Instructions Owner's manual Support Matrix

Dell PowerVault MD3200 Deployment Manual Manual pdf 29 page image

Post Installation Tasks 294Post Installation TasksBefore using the PowerVault™ MD3200 Series storage array for the first time,complete a number of initial configuration tasks in the order shown. Thesetasks are performed using the MD Storage Manager (MDSM) software.1 For out-of-band management, you must set the network configuration foreach RAID controller module, including its Internet Protocol (IP) address,subnetwork mask (subnet mask), and gateway.NOTE: You can set the network configuration using a DHCP server.2 Start MDSM.• On Microsoft® Windows® operating systems, click StartProgramsDellMD Storage ManagerModular Disk StorageManager Client.• On Linux operating systems, click the MD Storage Manager desktopicon. You can also launch MD Storage Manager in Linux by runningthe following commands at the command prompt:cd/opt/dell/mdstoragesoftware/mdstoragemanager/client./SMclient3 In the Enterprise Management Window (EMW), go to Setup AddStorage Array and start the automatic discovery of systems.NOTE: Only storage arrays configured with IP address on the same subnet asthe management stations will be detected.NOTE: It may take several minutes for the discovery process to complete.Closing the Automatic Discovery Status window before this stops thediscovery process.After discovery is complete, a confirmation screen appears. Click Close toclose the screen.Downloaded from www.Manualslib.com manuals search engine