Dell PowerVault MD3660f Deployment Manual

Also see for PowerVault MD3660f Series: Manual Configuration guide Installation and configuration guide Hardware and software guide Installation guide

Dell PowerVault MD3660f Deployment Manual Manual pdf 23 page image

Installing Fibre Channel CablesWARNING: Data processing environments can contain equipment transmitting on system links with laser modulesthat operate at greater than Class 1 power levels. Never look into the end of an optical fiber cable or openreceptacle.Before installing an FC cable, see Guidelines For Using Fibre Optic Cables.To install an FC cable:1. If applicable, remove the protective cap from the SFP module and store the protective cap for future use.2. Remove the two protective caps from one end of the cable and store them for future use.3. Insert the cable into an SFP module that is installed in the storage array. The cable connector is keyed for correctinstallation. Holding the connector, push in the cable until it clicks into place.4. Remove the two protective caps from the other end of the cable and store them future use.5. Connect this end of the cable to one of the following devices:– An SFP module that is installed in an FC switch port– An FC HBA portRemoving Fibre Channel CablesTo remove an FC cable:1. Press and hold the lever to release the latches before removing the cable from the SFP module. Ensure that thelevers are in the released position when removing the cable. Do not grasp the SFP module plastic tab whenremoving the cable.2. On the end of the cable that connects into the SFP module or HBA, press down and hold the lever to release thelatches.3. While pressing down the cable lever, pull the connector to remove the cable from the SFP module.4. Replace the protective caps on the cable ends.5. Replace the protective cap on the SFP module.23

/ 26

Related manuals for Dell PowerVault MD3660f Series