iSCSI for TL-Series Tape LibrariesSet-up of the TL2000/TL4000 with iSCS-to-SAS bridge card follows the same process:Figure 13 : TL2000 / TL4000 1Gb iSCSI to SAS BridgeSelect Connections and set the IP address and frame size for the port(s).Figure 14 : Set IP Address and Frame Size10SEPTEMBER 2008STORAGE TARGETS : TL2000 / TL4000SECTION 5Assuming a Dell PowerVault MD3000i, an iSCS disk array, is connect to the example network,the initial configuration would require physically installing & powering on the unit and then in-stalling and running Modular Disk Storage Manager (MDSM) on the host computer. After in-stallation of MDSM has been completed on the host computer, the disk array must be discov-ered by the host. The default management IP addresses for the MD3000i are192.168.128.101 for Controller 0 and 192.168.128.101 for Controller 1. After these addressesare used to establish connectivity to the unit, the remaining steps include setting up diskgroups, creating virtual disks, and assigning LUNs (Logical Unit Numbers) to the virtual disks.More information on this can be found in the documentation for the MD3000i onwww.support.dell.com. To configure the iSCSI settings, go to the iSCSI tab in MDSM (Figure15). To configure the host ports, select “Configure iSCSI Host Ports” (Figure 16). There are 2Host Ports on each controller, and they are, by default, assigned IP addresses192.168.130.101-102 and 192.168.131.101-102. The Advanced button will enable the user tochange settings for VLAN support, Ethernet priority, TCP listening port, and Ethernet Jumboframes. Enable Jumbo Frames and select 9000 for the Bytes/frame size.CONFIGURING AN MD3000iSECTION 6