Configuring the iSCSI bridgeDell Model TL24iSCSIxSAS 1Gb iSCSI to SAS User’s Guide Rev.C Page 277.6 iSCSI TargetThis configuration page will allow the user to configure the iSCSI Target. Click on the iSCSI Target iconunder SCSI Systems. The following page will be shown.Figure 22 iSCSI Target configuration page7.6.1 CHAP SettingsCHAP is an authentication scheme used by Servers to validate the identity of clients and vice versa. WhenCHAP is enabled, the initiator must send the correct Username and Target Password to gain access to theiSCSI bridge. The Initiator Secret is provided to allow iSCSI mutual CHAP. If mutual CHAP is selected on theInitiator, the iSCSI bridge will authenticate itself with the initiator using the initiator secret.To enable CHAP click the ‘CHAP Enabled’ tick box and enter the following details:• Username – this is the username that the iSCSI Initiator must use to gain access to the iSCSI bridge• Initiator Secret – this is the password that the iSCSI bridge will send to the iSCSI Initiator duringmutual CHAP• Target Secret – This is the secret defined by the iSCSI bridge and will be sent from the ISCSIInitiator to authenticate the iSCSI Initiator.The two CHAP secrets must be between 12 and 16 characters long and both Initiator and Target Secretsmust be different.