Disk Dri ves and Media 876 If the chassis drive bay was previously empty, remove thecorresponding insert from the front panel.Hold the front panel with the outside facing you. Press the ends of theinsert with your thumbs until the insert snaps free of the front panel.7 Replace the front panel.8 Rotate the power supply back into position until the securing tabsnaps into the release latch.9 Replace the computer cover and restart the system.10 If the drive you installed is a hard drive, enter system setup, andupdate the drive settings.After you update the system settings, exit system setup and reboot thecomputer.11 If the device you installed is a hard drive, partition and logically formatthe drive before proceeding to the next step.See the operating systemís documentation for instructions.12 Test the drive to verify that it is operating properly.ï If the drive you installed is a hard drive, run the Dell Diagnosticsto test the drive.ï For other types of drives, see the driveís documentation forinformation on testing the drive.13 If the drive you installed is the primary hard drive, install the operatingsystem on the drive.See the operating systemís documentation for instructions.NOTE: Tape drives sold by Dell come with their own operating software anddocumentation. After you install a tape drive, refer to the documentation thatcame with the drive for instructions on installing and using the tape drivesoftware.Removing a Hard Drive (Mini Tower Chassis)CAUTION: Before you perform this procedure, see "PrecautionaryMeasures."
