26 Setup and Quick Reference Guid ew w w . d e l l . c o m | s u p p o r t . d e l l . c o m4 When the tests are completed, if you are running the Dell Diagnostics from theDrivers and Utilities CD, remove the CD.5 Close the test screen to return to the Main Menu screen. To exit the Dell Diagnosticsand restart the computer, close the Main Menu screen.Beep CodesYour computer might emit a series of beeps that identify a problem. One possible series(code 1-3-1) consists of one beep, a burst of three beeps, and then one beep. This series tellyou that the computer encountered a memory problem.If a beep code is emitted, write it down and look it up under "Beep Codes" in the User’sGuide.Error MessagesNOTE: If the message is not listed, see the documentation for either the operating system or theprogram that was running when the message appeared.If an error occurs during start-up, a message may be displayed on the monitor identifyingthe problem. See "Error Messages" in the User’s Guide for suggestions on resolving anyproblems.Tab FunctionResults Displays the results of the test and any error conditionsencountered.Errors Displays error conditions encountered, error codes,and the problem description.Help Describes the test and may indicate requirements forrunning the test.Configuration Displays your hardware configuration for the selecteddevice.The Dell Diagnostics obtains configurationinformation for all devices from system setup, memory,and various internal tests, and it displays theinformation in the device list in the left pane of thescreen. The device list may not display the names of allthe components installed on your computer or alldevices attached to your computer.Parameters Allows you to customize the test by changing the testsettings.C0931eb0.fm Page 26 Tuesday, February 25, 2003 4:09 PM