Back to Contents PageDisplay AssemblyDell Precision ™ M2300 Service ManualRemoving the Display AssemblyRemoving the Display BezelRemoving the Display PanelRemoving the Display Panel BracketsRemoving the Display Panel CableRemoving the Display HingesRemoving the Display Assembly1. Follow the instructions in Before You Begin.2. Remove the hinge cover (see Hinge Cover).3. Remove the keyboard (see Removing the Keyboard).4. Review the cable routing diagram:5. Pull straight up on the pull-tab that is attached to the display cable to disconnect the cable from the system board.6. Disconnect the antenna cables from their card(s) (see Communications Cards).7. Carefully remove the antenna cables and the display cable from their routing guides.8. Close the display.9. Turn the computer upside down with the back of the computer facing you.CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Dell™ Product Information Guide.CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metalsurface, such as a connector on the back of the computer.1 WWAN/FCM cardconnector2 WWAN antenna cables 3 WLAN antenna cables(black and white)4 WLAN card 5 pull-tab 6 display cable7 WLAN antenna cables(white and gray)8 WLAN antenna cable (gray;currently unused)NOTICE: To avoid damage to your computer, use the illustration above when replacing the display assembly to carefully reroute the cables in theappropriate cable channels. Route the gray and black antenna cables beneath the white antenna cable, and the black display cable on top of the whiteantenna cable.