Dell Precision Workstation 350 Service Manual

Also see for Precision Workstation 350: Installation guide Information update System information guide Setup and quick reference guide Setup and quick reference guide

Back to Contents PagePCI CardsDell Precision™ Workstation 350 Service ManualYour computer provides four slots for 32-bit 33-MHz cards. For more information, see "Specifications" in your User's Guide or "System Board" in this document.If you are installing or replacing a card, follow the procedures in the next section. If you are removing but not replacing a card, see "Removing a Card."Installing a Card1. If you are replacing a card, remove the current driver for the card from the operating system.2. If you are replacing a hard drive that contains data you want to keep, back up your files before you begin this procedure.3. Press the lever on the card retention arm and raise the retention arm.4. If you are installing a new card, remove the filler bracket to create a card-slot opening. Then continue with step 6.5. If you are replacing a card that is already installed in the computer, remove the card.If necessary, disconnect any cables connected to the card. Grasp the card by its top corners, and ease it out of its connector.6. Prepare the card for installation.See the documentation that came with the card for information on configuring the card, making internal connections, or otherwise customizing it for yourcomputer.7. Place the card in the connector and press down firmly. Ensure that the card is fully seated in the slot.If the card is full-length, insert the end of the card into the card guide bracket as you lower the card toward its connector on the system board. Insertthe card firmly into the card connector on the system board.CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the System Information Guide.NOTE: To meet PC99 requirements, your Dell™ computer uses only PCI slots. ISA cards are not supported.1 card2 edge connector3 card connector4 retention arm5 lever6 filler bracketCAUTION: Some network adapters automatically start the computer when they are connected to a network. To guard against electrical shock, besure to unplug your computer from its electrical outlet before installing any cards. Verify that the standby power light on the system board is off.To locate this light, see "System Board."