Using Your Projector 45NOTE:1. When you want to create 3D experience, you will need a few other componentsincluding:a PC/NB with a 120 Hz signal output quad buffered graphics card.b "Active" 3D glasses with DLP Link™.c 3D content. See "Note 4".d 3D Player. (Example: Stereoscopic Player...)2. Enable the 3D function when it satisfies any of the below-mentioned conditions:a PC/NB with graphics card, capable of outputting at 120 Hz signal via VGA orHDMI cable.b Input a suite of 3D content via Video and S-Video.3. When projector detects either of the inputs (mentioned above), the enable 3Ddisplay on "SETUP" -> "3D Display" OSD works.4. Current 3D support time is as indicated:a VGA/HDMI 1280 x 720 120 Hzb Composite/S-Video 60 Hzc Component 480i5. The recommended VGA signal for NB is Single mode output (Dual mode is notrecommended)3D Sync Invert—If you see a discrete or overlapping image whilewearing DLP 3D goggles, you may need to execute 'Invert' to getbest match of left/right image sequence to get the correct image.(For DLP 3D goggles)Wireless / Network—Select On to activate wireless / network function. Pressto configure the Wireless / Network settings.
