Dell S4048-ON Configuration Manual

Also see for S4048-ON: Deployment guide Troubleshooting guide Configuration guide Configuration guide Configuration guide

Contents

Switch configuration (OS 9.x)17 Dell EMC Networking S4048-ON Switch Configuration Guide for Dell PS Series SANs | SCG10262.4.8 Configure login credentialsDell(conf)#username admin privilege 15 password 0 <yourpassword>Dell(conf)#enable password level 15 0 <yourpassword>2.4.9 Configure switch portsDell(conf)#interface range tengigabitethernet 1/1–1/48Dell(conf-if-range-te-1/1-48)#mtu 12000Dell(conf-if-range-te-1/1-48)#switchportDell(conf-if-range-te-1/1-48)#spanning-tree rstp edge-portDell(conf-if-range-te-1/1-48)#flowcontrol rx on tx offDell(conf-if-range-te-1/1-48)#no shutdownDell(conf-if-range-te-1/1-48)#exitDell(conf)#interface range tengigabitethernet 2/1–2/48Dell(conf-if-range-te-2/1-2/48)#mtu 12000Dell(conf-if-range-te-2/1-2/48)#switchportDell(conf-if-range-te-2/1-2/48)#spanning-tree rstp edge-portDell(conf-if-range-te-2/1-2/48)#flowcontrol rx on tx offDell(conf-if-range-te-2/1-2/48)#no shutDell(conf-if-range-te-2/1-2/48)#exitDell(conf)# protocol spanning-tree rstpDell(conf-rstp)#no disableDell(conf-rstp)#exitDell(conf)#exit2.4.10 Save configuration and reloadDell#copy running-config startup-configReload the stack to allow settings to take effect:Dell#reloadNote: The preceding procedure places all switch ports in the default VLAN. If you prefer to place ports in anon-default VLAN, refer to the switch documentation.