Dell S4810 Configuration Manual

Also see for Force10 S4810: Quick start guide Deployment guide Configuration guide

Contents

15 SCG1000 Force10 S4810 Configuration Guide4.3 Revert to default VLAN ID on switch and arraysOnce DCB is disabled on the switch, the EqualLogic arrays will no longer use the VLAN ID that wasconfigured when DCB was enabled. The arrays will revert to the default or native VLAN. Therefore, a validVLAN must be configured for all host servers, switches, and EqualLogic array members. A valid VLAN canuse the default or native VLAN ID (typically 0 or 1) or a specific VLAN can be configured (for example,VLAN 100). If a non-default VLAN is configured, then any ports connected to the arrays must beconfigured as “untagged”.Use the steps below to configure the native VLAN on the switch.FTOS#configureFTOS(conf)#no interface vlan vlan-id4.4 Save configurationFTOS#copy running-config startup-config4.5 ReloadFTOS#reloadSystem configuration has been modified. Save? [yes/no]yesProceed with reload [confirm yes/no]yesNote: The switch will reboot.4.6 Verify DCB statusFTOS#show dcbFigure 2 Screen shot of show DCB4.7 Configure additional switchRepeat the commands from section 4 to disable DCB on any additional switches.

/ 17

Related manuals for Dell Force10 S4810