Dell S6000-ON Getting Started Manual

Also see for S6000-ON: Troubleshooting guide Configuration guide Installation guide

Contents

Dell S6000-ON Getting Started Manual Manual pdf 15 page image

12 InstallationInstalling an AC Power SupplyTo install an AC power supply, follow these steps.NOTE: The PSU slides into the slot smoothly. Do not force the PSU into a slot asthis may damage the PSU or the S6000-ON chassis.NOTE: Ensure that the PSU is correctly installed. When the PSU is correctlyinstalled, the power connector is on the left side of the PSU and the status LED is atthe bottom of the PSU.NOTE: If you use a single PSU, install a blank plate in the other PSU slot. DellNetworking recommends using power supply 2 (PSU2) as the blank plate slot.Step Task1 Remove the PSU slot cover from the S6000-ON (the PSU side of switch). Youmay select either of the two PSU slots.2 Remove the PSU from the electro-static bag.3 Insert the PSU into the switch PSU slot (insert the PSU exposed PCB edgeconnector first).The PSU slot is keyed such that the PSU can only be fully inserted in oneorientation.1 - PSU2 - SlotWhen the PSU is installed correctly, it snaps into place and is flushed with theback of the switch.