Back to Contents PageSolving ProblemsDell™ SR2320L monitor User's GuideSelf-TestBuilt-in DiagnosticsCommon ProblemsProduct-Specific ProblemsTroubleshooting the Dell™ Soundbar (Optional)Self-TestYour monitor provides a self-test feature that allows you to check whether your monitor is functioning properly. If your monitor and computer are properlyconnected but the monitor screen remains dark, run the monitor self-test by performing the following steps:1. Turn off both your computer and the monitor.2. Unplug the video cable from the back of the computer. To ensure proper Self-Test operation, remove the Analog (blue connector) cable from the back ofcomputer.3. Turn on the monitor.4. This box also appears during normal system operation, if the video cable becomes disconnected or damaged. The monitor will enter Power Save Modeafter 15 minutes if left at this state.5. Turn off your monitor and reconnect the video cable; then turn on both your computer and the monitor.If your monitor screen remains blank after you have performed Step 5, check your video controller and computer system.Built-in DiagnosticsYour monitor has a built-in diagnostic tool that helps you determine if the screen abnormality you are experiencing is an inherent problem with your monitor, orwith your computer and video card.To run the built-in diagnostics:1. Ensure that the screen is clean (no dust particles on the surface of the screen).2. Unplug the video cable(s) from the back of the computer or monitor. The monitor then goes into the self-test mode.3. On the front panel, press and hold the shortcut button 1 and shortcut button 4 keys on the front panel, simultaneously for 2 seconds. A gray screenappears.WARNING: Before you begin any of the procedures in this section, follow the Safety Instructions.The floating dialog box should appear on-screen (against a black background) if the monitor cannot sense a video signal and is working correctly.While in self-test mode, the power LED remains white. Also, the dialog shown below will continuously scroll through the screen.or