Dell Studio 1555 Service Manual

Also see for 1555 - Studio - Chainlink: User guide Setup guide Service manual

Back to Contents PageFanDell Studio™ 1555 Service ManualRemoving the FanReplacing the FanRemoving the Fan1. Follow the instructions in Before You Begin.2. Remove the optical drive (see Removing the Optical Drive).3. Disconnect the AC adapter connector cable, USB cable, fan cable, and the subwoofer cable from the system board.4. Remove the six screws that secure the system board to the computer base.5. Lift the system board off the computer base.6. Remove the two screws that secure the fan to the computer base.7. Lift the fan off the computer base.Replacing the Fan1. Place the fan on the computer base and replace the two screws that secure the fan to the computer base.2. Place the system board on computer base.3. Replace the six screws that secure the system board to the computer base.4. Connect the AC adapter connector cable, USB cable, fan cable, and the subwoofer cable to their respective connectors on the system board.WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metalsurface (such as a connector on the back of the computer).CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™is not covered by your warranty.CAUTION: To help prevent damage to the system board, remove the main battery (see Before Working Inside Your Computer) before workinginside the computer.1 screws (2) 2 fan cable