Dell Studio XPS 1640 Service Manual

Also see for Studio XPS 1640: User guide Setup guide Setup guide

Back to Contents PageHard DriveDell™ Studio XPS™ 1640 Service ManualRemoving the Hard DriveReplacing the Hard DriveRemoving the Hard Drive1. Follow the instructions in Before You Begin.2. Remove the base cover (see Removing the Base Cover).3. Remove the three screws securing the hard drive assembly to the computer base.4. Pull the blue pull-tab to disconnect the hard drive assembly from the system board connector.5. Lift the hard drive assembly out of the computer base.6. Remove the four screws that secure the hard drive bracket to the hard drive and remove the bracket.CAUTION: If you remove the hard drive from the computer when the drive is hot, do not touch the metal housing of the hard drive.CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.NOTICE: To prevent data loss, turn off your computer (see Turning Off Your Computer) before removing the hard drive. Do not remove the hard drivewhile the computer is on or in Sleep state.NOTICE: Hard drives are extremely fragile. Exercise care when handling the hard drive.NOTICE: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is notcovered by your warranty.NOTICE: To help prevent damage to the system board, remove the main battery (see Before Working Inside Your Computer) before working inside thecomputer.NOTE: Dell does not guarantee compatibility or provide support for hard drives from sources other than Dell.NOTE: If you are installing a hard drive from a source other than Dell, you need to install an operating system, drivers, and utilities on the new harddrive (see the Dell Technology Guide).NOTICE: When the hard drive is not in the computer, store it in protective antistatic packaging (see "Protecting Against Electrostatic Discharge" in thesafety instructions that shipped with your computer).1 hard drive assembly 2 screws (3)3 blue pull-tab