Before contacting Customer Service, pleaserefer to the Guide on CD-ROMConnecting your Monitor to a Computer1. Turn off your computer and unplug its power cable.2. Connect the blue connector of signal cable to theblue video port on the back of your computer. Besure to tighten jack screws finger tight. Do not over-tighten.3. Fully insert the power cable into the power port onthe back of the monitor.4. Plug the power cables of your computer and yourmonitor into a nearby outlet.5. Turn on your computer and monitor. If the monitordoes not display an image please go to the troubleshooting section of this guide.Driver Installation Monitor Controls and IndicatorsWhen prompted by the operating system for the monitor drivers,insert the CD and select the CD-ROM as the disk containing the driv-ers.WINDOWS 98Windows 98 will auto-detect the new monitor and start the “Add NewHardware Wizard” if the drivers are not already installed.S Click the NEXT button to search for drivers. Check the CD-ROMdrive box to install the drivers of the CD-ROM and click NEXT.Confirm Windows found the drivers on the CD-ROM and clickNEXT again to install the drivers.S To manually install or update the driver, click START, SETTINGS,CONTROL PANEL, DISPLAY SETTINGS tab, ADVANCED, MON-ITOR tab, CHANGE. This will start the “Update Device Driver Wiz-ard”. Follow the same steps as the “Add New Hardware Wizard”above.WINDOWS 95To determine the Windows 95 version, right click on the “My Comput-er” icon on the desktop and select “Properties”. The version numberis listed under the “System” section.S Version 4.00.950A --- Click on START, SETTINGS, CONTROL PAN-EL, DISPLAY, SETTINGS tab, CHANGE DISPLAY TYPE, CHANGE,HAVE DISK, type the CD-ROM drive letter in the box and click OK.S Version 4.00.950B --- Click on START, SETTINGS, CONTROLPANEL, DISPLAY, ADVANCED PROPERTIES, MONITOR tab, HAVEDISK, type the CD-ROM drive letter in the box and click OK.Power Switch1. Push the power switch to turn the monitor on and off. The indica-tor light up green when the monitor is onMenu2. Displays the menu andS activates a highlighted function for adjustmentS returns the menu display after adjustment3. Plus (+) and minus ( ---) buttons are usedS for selection of an item in the menuS for adjustment of an activated propertyDirect access adjustmentYou may call contrast adjustment to the screen by pushing plus (+)or minus ( ---) without having menu on screen.