Dell Virtual Edge Platform 4600 Setup Manual
Also see for VEP4600: Installation guideOperating system installation guideInstallation guideInstallation guide
                       | |
Before you install the switch into the dual-tray:1 Cut the ground cable (not included) to the desired length. The cable length mustfacilitate proper operation of the fault interrupt circuits. Use the shortest cable routeallowable.2 Unscrew the two attached M3 screws and set aside.3 Attach the ground lug and bracket to the switch using the M3 screws.Figure 2. VEP4600 ground lug attached4 Attach the other end of the ground cable to a suitable ground point such as the rack orcabinet.Rack or cabinet installationYou may either place the platform on a rack shelf or mount the platform directly into a 19"wide, EIA-310- E-compliant rack.The platform includes two-post rail assemblies.WARNING: This guide is a condensed reference. Read the safety instructions inyourSafety, Environmental, and Regulatory information booklet before you begin.12 VEP4600 installation |
Related manuals for Dell VEP4600
Dell EMC Virtual Edge Platform 1405 Series Operating System Installation Manual
Dell VEP1400 Series Setup Manual
Dell EMC VEP4600 Installation Manual
Dell EMC SD-WAN Edge 3000 Series Activation Manual
Dell PowerEdge FC830 Owner's Manual
Dell MC SD-WAN Edge 3400 Advanced Activation Manual
Dell VxRail P570 Owner's Manual
Dell CX4 Series User Manual
Dell EMC VEP4600 Operating System Installation Manual
Dell DD9410 Manual
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine