SecurityTable 27. SecurityOption DescriptionAdmin Password Allows you to set, change, and delete the admin password.System Password Allows you to set, change, and delete the system password.Strong Password This option lets you enable or disable strong passwords for the system.Password Configuration Allows you to control the minimum and maximum number of characters allowed for a administrativepassword and the system password. The range of characters is between 4 and 32.Password Bypass This option lets you bypass the System (Boot) Password and the internal HDD password promptsduring a system restart.• Disabled — Always prompt for the system and internal HDD password when they are set. Thisoption is enabled by default.• Reboot Bypass — Bypass the password prompts on Restarts (warm boots).NOTE: The system will always prompt for the system and internal HDD passwords whenpowered on from the off state (a cold boot). Also, the system will always prompt forpasswords on any module bay HDDs that may be present.Password Change This option lets you determine whether changes to the System and Hard Disk passwords arepermitted when an administrator password is set.Allow Non-Admin Password Changes - This option is enabled by default.Non-Admin Setup Changes Determines whether changes to the setup option are permitted when an administrator password isset.UEFI Capsule Firmware Updates This option controls whether this system allows BIOS updates via UEFI capsule update packages.This option is selected by default. Disabling this option will block BIOS updates from services such asMicrosoft Windows Update and Linux Vendor Firmware Service (LVFS)TPM 2.0 Security Allows you to control whether the Trusted Platform Module (TPM) is visible to the operating system.• TPM On (default)• Clear• PPI Bypass for Enable Commands• PPI Bypass for Disable Commands• PPI Bypass for Clear Commands• Attestation Enable (default)• Key Storage Enable (default)• SHA-256 (default)Choose any one option:• Disabled• Enabled (default)Computrace(R) This field lets you Activate or Disable the BIOS module interface of the optional Computrace Servicefrom Absolute Software. Enables or disables the optional Computrace service designed for assetmanagement.• Deactivate• Disable• Activate - This option is selected by default.System setup 25