Installing the system board1 Align the screw holes on the system board with the screw holes on the system.2 Replace the six M2.0 x 2 screws to secure the system board to the computer.3 Align the screw holes of the USB Type C bracket with the screw holes on the system board and replace the two screws to secure thebracket to the system.4 Connect the eDP cable, power adapter port cable and speaker cable to the connector in the system board.5 Connect the Input output board cable, speaker cable, keyboard backlight cable, keyboard cable and touchpad cable to the systemboard.6 Install the:a solid state drive(SSD)b heat sinkc system fand batterye base cover7 Follow the procedure in After working inside your computer.TouchpadRemoving touchpad1 Follow the procedure in Before working inside your computer.2 Remove the:a base coverb battery3 To remove the touchpad:a Peel the adhesive from the touchpad.b Remove the four M2.0 x 2 screws that secure the touchpad to the system [1].c Disconnect the touchpad cable from the connector in the system [2].24 Removing and installing components