Dell Wyse 3000-Xenith 2 Quick Start Manual

Dell Inc.One Dell WayRound Rock, TX 78664 USA883939-01L Rev. KAugust 2014Printed in ChinaSafety GuidelinesImproper connection or use of this product could result in component failure or undesired interference.Read the following guidelines before setting up and operating your device.Setup• Do not connect to AC power until all other connections (including the power adapter) are made.Connecting or disconnecting components or equipment on the back panel when the device is receivingAC power can cause power surges and damage the device.• Do not force a connector into its socket. If any undue resistance is encountered, ensure that theconnector is correctly oriented to the receptacle.• Not all USB devices are supported; check with Dell or your Dell representative to find out if a particulardevice is supported on your device.• For wireless usage and requirements, refer to the regulatory notices in the device’s documentation.Venting and Care• Mount the device only as shown or in accordance with the instructions provided with Dell-approveddevice and damage it.• Allow sufficient space around the device for ventilation; do not place the device in any enclosure thatrestricts airflow around the device; do not place any objects on the device or block the vent outlets. Findenvironmental operating specifications in the product Spec Sheet at www.dell.com/wyse/xenith3.Power Sources• For regulatory compliance use only the power adapter that comes with your device or a Dell-approvedequivalent. For proper replacement compare the labels on both device and power adapter to ensure thattheir voltages match.Warning: Use of any other power adapter may damage your device or the power adapter. The damagecaused by an improper power adapter is not covered by warranty.• Accidental loss of power can damage the device. Avoid connecting it to any power outlet which can beaccidentally switched off. Do not hard reset the device by holding down the power button during normaloperation.• When turning off the device, be sure to perform a complete shutdown (via the user interface or a lightpress on the power button). Do not disconnect the AC power cord, DC power cord, or shut off power at acircuit breaker (including power strips), etc., to turn off the device.• Surge protectors for electrical devices are recommended in areas of lightning. However, whenlightning is occurring, your equipment should be properly shut down and unplugged from AC power untilthe storm has passed.• Be very careful to not interrupt power while the device is downloading a software update.Battery• The device contains an internal button cell battery replaceable by Dell or one of our Authorized ServiceBACKShutting Down Wyse XenithLightly press the power button on Wyse Xenith to shutdown.Signing Off from Wyse XenithAfter you disconnect from your desktop, if you are not automatically signed offfrom Wyse Xenith, you can use the Shutdown icon in the Wyse Xenith toolbar toselect Sign-off from account.Administrators: Refer to the administrators guide to set up auto-signoff from WyseXenith.Need More Information?Dell Reference Guides – Xenith Administrator and related documentation is available at:www.dell.com/wyse/manualsDell Wyse Xenith Spec Sheet – Wyse Xenith features can be found in the Spec Sheet for yourspecific zero client model. Spec Sheets are available at: www.dell.com/wyse/Xenith3Dell-Approved Mounting Accessory Kits – Information about approved mounting accessorykit options is available at: www.dell.com/wyse/accessoriesDell Service and Support – Latest software images are available at:www.dell.com/wyse/supportDell ® Wyse Device Manager – Information about Dell remote managementsoftware is available at: www.dell.com/wyse/WDMDell and the Environment – Information about Dell compliance withRoHS and with the Waste Electrical and Electronic Equipment (WEEE)is available at: www.dell.com/environmentDell and Recycling – Information about recycling and reuseof Dell products is available at: www.dell.com/recycling

/ 2

Related manuals for Dell 3000-T00X