Dell XPS /Dimension Gen 5 Service Manual

Also see for studio XPS: Product information guide Owner's manual Owner's manual Setup guide Owner's manual

Contents

Dell XPS /Dimension Gen 5 Service Manual Manual pdf 15 page image

5. Insert the module into the connector until the module snaps into position.If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.6. Close the computer cover.7. Connect your computer and devices to electrical outlets, and turn them on.8. Right-click the My Computer icon and click Properties.9. Click the General tab.10. To verify that the memory is installed correctly, check the amount of memory (RAM) listed.Removing Memory1. Follow the procedures in "Before You Begin."2. Press out the securing clip at each end of the memory module connector.3. Grasp the module and pull up.If the module is difficult to remove, gently ease the module back and forth to remove it from the connector.CardsYour computer provides the following slots for PCI and PCI Express cards:l Three PCI card slotsl One PCI Express x16 card slotl One PCI Express x4 card slotl One PCI Express x1 card slotExpansion CardsNOTICE: To avoid damage to the memory module, press the module straight down into the connector while you apply equal force to each end of themodule.NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into your computer.CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of yourcomputer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of yourcomputer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.NOTE: The installation and removal instructions are the same for the four types of expansion cards listed below.