Dell XPS L502X Service Manual

Also see for XPS L502X: Setup guide Service manual Service manual

Contents

Display 57Replacing the Display Panel1 Follow the instructions in "Before You Begin" on page 9.2 Place the display panel over the display back cover.3 Route the display cable through the routing guide on the left displayhinge.4 Route the antenna cables through the routing guide on the right displayhinge.5 Replace the ten screws that secure the display panel to the display backcover.6 Replace the two screws that secure the digitizer board to the display backcover.7 Connect the camera cable to the connector on the camera module.8 Connect the digitizer board cable to the connector on the digitizer board.9 Replace the display bezel (see "Replacing the Display Bezel" on page 54).10 Replace the display assembly (see "Replacing the Display Assembly" onpage 52).CAUTION: Before turning on the computer, replace all screws and ensure that nostray screws remain inside the computer. Failure to do so may result in damage tothe computer.Display CableRemoving the Display Cable1 Follow the instructions in "Before You Begin" on page 9.2 Remove the display assembly (see "Removing the Display Assembly" onpage 49).3 Remove the display bezel (see "Removing the Display Bezel" on page 53).4 Remove the display panel (see "Removing the Display Panel" on page 54).5 Turn the display panel over and place it on a clean surface.6 Pull the pull-tab to disconnect the display cable from the connector on thedisplay panel.