Dell optiplex 330 Quick Reference Manual

Also see for OptiPlex 330: System information guide User guide Service manual Setup and features information User guide

Contents

Dell optiplex 330 Quick Reference Manual Manual pdf 62 page image

62 Quick Reference GuideNOTICE: To connect a network cable, first plug the cable into the network wall jackand then plug it into the computer.13 Connect your computer and devices to electrical outlets, and turnthem on.NOTE: This procedure enables the password feature. When you enter systemsetup (see "Entering System Setup" in your User’s Guide), both system andadministrator password options appear as Not Set—meaning that the passwordfeature is enabled but no password is assigned.14 Assign a new system and/or administrator password.Clearing CMOS SettingsCAUTION: Before you begin any of the procedures in this section, follow thesafety instructions located in the Product Information Guide.1 Follow the procedures in "Before You Begin" on page 10.NOTE: The computer must be disconnected from the electrical outlet to clearthe CMOS setting.2 Remove the computer cover (see "Removing the Computer Cover" onpage 43).3 Remove the computer cover.4 Reset the current CMOS settings:a Locate the password (PSWD) and CMOS (RTCRST) jumpers on thesystem board (see "Clearing Forgotten Passwords" on page 60).b Remove the password jumper plug from its pins.c Place the password jumper plug on the RTCRST pins and waitapproximately 5 seconds.d Remove the jumper plug from the RTCRST pins and place it back onthe password pins.5 Replace the computer cover (see "Replacing the Computer Cover" onpage 37).NOTICE: To connect a network cable, first plug the cable into the network port ordevice and then plug it into the computer.6 Connect your computer and devices to electrical outlets, and turnthem on.