Dell vostro 15-3562 Owner's Manual

Contents

Working on your computerSafety instructionsUse the following safety guidelines to help protect your computer from potential damage and to help to ensure your personal safety.Unless otherwise noted, each procedure included in this document assumes that the following conditions exist:• You have read the safety information that shipped with your computer.• A component can be replaced or--if purchased separately--installed by performing the removal procedure in reverse order.WARNING: Disconnect all power sources before opening the computer cover or panels. After you finish working inside thecomputer, replace all covers, panels, and screws before connecting to the power source.WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additionalsafety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_complianceCAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simplerepairs as authorized in your product documentation, or as directed by the online or telephone service and support team.Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructionsthat came with the product.CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching anunpainted metal surface, such as a connector on the back of the computer.CAUTION: Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by itsedges or by its metal mounting bracket. Hold a component such as a processor by its edges, not by its pins.CAUTION: When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some cables haveconnectors with locking tabs; if you are disconnecting this type of cable, press in on the locking tabs before you disconnect thecable. As you pull connectors apart, keep them evenly aligned to avoid bending any connector pins. Also, before you connect acable, ensure that both connectors are correctly oriented and aligned.NOTE: The color of your computer and certain components may appear differently than shown in this document.Before working inside your computerTo avoid damaging your computer, perform the following steps before you begin working inside the computer.1 Ensure that you follow the Safety instructions.2 Ensure that your work surface is flat and clean to prevent the computer cover from being scratched.3 Turn off your computer (see Turning off your computer).4 If the computer is connected to a docking device (docked), undock it.CAUTION: To disconnect a network cable, first unplug the cable from your computer and then unplug the cable fromthe network device.5 Disconnect all network cables from the computer.6 Disconnect your computer and all attached devices from their electrical outlets.7 Close the display and turn the computer upside-down on a flat work surface.NOTE: To avoid damaging the system board, you must remove the main battery before you service the computer.8 Remove the main battery.9 Turn the computer top-side up.16 Working on your computer