Replacing the solid-state driveWARNING: Before working inside your computer, read the safety information that shipped with your computer and follow thesteps in Before working inside your computer. After working inside your computer, follow the instructions in After working insideyour computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.CAUTION: Solid-state drives are fragile. Exercise care when handling the solid-state drive.Topics:• Procedure• Post-requisitesProcedure1 Align the notches on the solid-state drive with the tabs in the solid-state drive slot, slide the solid-state drive at an angle into the solid-state drive slot, then press the other end of the solid-state drive down.2 Align the screw holes on the hard disk plate with the screw holes on the system board.3 Replace the two screws (M1.6x2.5) that secure the hard-disk plate to the system board.4 Adhere the display-cable tape to the hard-disk plate.Post-requisites1 Replace the battery.2 Replace the base cover.816 Replacing the solid-state drive