Delta 14-65l Instruction Manual

Contents

Delta 14-65l Instruction Manual Manual pdf 7 page image

7 - EnglishATTACHING THE TOOL AND CHISEL HOLDER1. Attach the tool and chisel holder (A) Fig. 5 to the back of the column, using the two M6x1x25mm screws (B) andM6 lockwashers.2. Fig. 6 illustrates the stored chuck key/wrench (C), bushing (F) for use with extra long chisels, and chisels and bits (E).RAISING AND LOWERING THE HANDLE1. Attach the hub of the handle assembly (A) Fig. 1 to the end of the pinion shaft (B). Fasten the handle to the pinionshaft using the special screw (C) and spring (D).2. Raise the mortising machine head (E) Fig. 2 to the "up" position by turning the handle (A) clockwise.NOTE: The handle (A) is spring-loaded. Reposition it by pulling it out and moving it on pinion shaft (B).ATTACHING THE HYDRAULIC CYLINDERPlace the head (A) Fig. 3 in the “up” position. Attach the hydraulic cylinder (B) to the two fittings, one located on theback of the head (C) Fig. 3, and the other on the column (D) Fig. 4. Push each end of the hydraulic cylinder on its fittingto secure the cylinder.Fig. 1 Fig. 2BEBAFig. 3 Fig. 4CABDBABBAFCEFig. 5 Fig. 6ASSEMBLYFor your own safety, do not connect the machine to the power source until the machine iscompletely assembled and you read and understand the entire instruction manual.ADCASSEMBLY TOOLS REQUIREDASSEMBLY TIME ESTIMATEAssembly for this machine takes less than 30 minutes.Chuck Key/Wrench (Supplied)