AH 5 00 Pr ogr am m ing Ma n ua l7 - 2 6Error code DescriptionLED indicator statusCPU ModuleBUSFAULT ERROR16#A009 The pointer used in JMP is the same as the pointerused in CALL. Blinking16#A00B Target position (I) of the single speed is incorrect. Blinking16#A00C Target position (II) of the single-axis motion isincorrect. Blinking16#A00D The setting of speed (I) of the single-axis motion isincorrect. Blinking16#A00E The setting of speed (II) of the single-axis motion isincorrect. Blinking16#A00F The setting of the speed (V RT) of returning to zero isincorrect. Blinking16#A010 The setting of the deceleration (VCR ) of returning tozero is incorrect. Blinking16#A011 The setting of the JOG speed is incorrect. Blinking16#A012 The positive pulses generated by the single-axisclockwise motion are inhibited. Blinking16#A013 The negative pulses generated by the single-axiscounterclockwise motion are inhibited. Blinking16#A014 The limit switch is reached. Blinking16#A015 The device which is used exceeds the device range. Blinking16#A017 An error occurs when the device is modified by a 16-bitindex register/32-bit index register. Blinking16#A018 The conversion into the floating-point number isincorrect. Blinking16#A019 The conversion into the binary-coded decimal numberis incorrect. Blinking16#A01A Incorrect division operation (The divisor is 0.) Blinking16#A01B General program error Blinking16#A01C LD/LDI has been used more than nine times. Blinking16#A01D There is more than one level of nested programstructure supported by RPT/RPE. Blinking16#A01E SRET is used between RPT and RPE. Blinking16#A01F Incorrect division operation (The divisor is 0.) Blinking16#A020 The wrong instruction is used, or the device usedexceeds the range. Blinking7.1.6 AH10EN-5A / AH-15EN-5AError code DescriptionLED indicator statusCPU ModuleBUSFAULT Error16#A001 The IP address of host 1 conflicts with another systemon the network. Blinking16#A002 The IP address of host 2 conflicts with another systemon the network. Blinking16#A003 DHCP for host 1 fails. Blinking16#A004 DHCP for host 2 fails. Blinking16#A401 Hardware error ON16#A402 The initialization of the system fails. ON
