Delta C2000 series User Manual
Also see for C2000 Series: Product applicationUser manualUser manualUser manualUser manual
                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                      | |
Contents
| 
Chapter 6 Control TerminalsC2000 Series6-36-1 Specifications of Control TerminalMI1+24V COM FWDMO1 MI5MI3ACI+10V AVIAFM1 MO2 MCM MI7MI4DCM REV MI2S1 MI8MI6ACM-10V AUIAFM2 SCM DFM SG-SG+RA2RC2 RB2 RB1RC1 RA10-10V-10-10V0-10V 0-10V0-10V0-20mA 0-20mA0-20mA Open120AFM1 AFM2 AVI ACI 485Removable Terminal BlockABSGNDWire Gauge: 26~16AWG（0.1281-1.318mm2）,Torque: (A) 5kg-cm [4.31Ib-in.] (0.49Nm) (As shown in figure above)(B) 8kg-cm [6.94Ib-in.] (0.78Nm) (As shown in figure above)Wiring precautions: Reserves 5mm and properly install the wire into the terminal; fasten the installation by aslotted screwdriver. If the wire is stripped, sort the wire before install into the terminal. Flathead screwdriver: blade width 3.5mm, tip thickness 0.6mm In the figure above, the factory setting for S1-SCM is short circuit. The factory setting for+24V-COM is short circuit and SINK mode (NPN); please refer to Chapter 4 Wiring for moredetail.Terminals Terminal Function Factory Setting (NPN mode)+24V Digital control signal common(Source)+24V5% 200mACOM Digital control signal common(Sink)Common for multi-function input terminalsFWD Forward-Stop commandFWD-DCM:ON forward runningOFF deceleration to stopREV Reverse-Stop commandREV-DCM:ON reverse runningOFF deceleration to stopMI1~MI8Multi-function input 1~8Refer to parameters 02-01~02-08 to program themulti-function inputs MI1~MI8.ON: the activation current is 6.5mA 11Vdc≧OFF: leakage current tolerance is 10μA 11Vdc≦DFMDigital frequency meterDFMDCMDCM Digital frequency signal commonRegard the pulse voltage as the output monitor signalDuty-cycle: 50%Min. load impedance: 1kΩ/100pfMax. current: 30mAMax. voltage: 30VdcMO1 Multi-function Output 1(photocoupler)The AC motor drive releases various monitor signals,such as drive in operation, frequency attained andoverload indication, via transistor (open collector). |
Related manuals for Delta C2000 Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine