Delta DVPEN01-SL Operation Manual

Also see for DVPEN01-SL: Operation manual

Delta DVPEN01-SL Operation Manual Manual pdf 10 page image

Ethernet Communication Module DVPEN01-SLDVP-PLC Operation Manual8CR#HW LW Attribute Content Explanation#115 R/W Modbus TCP trigger Setting up whether to send out data in Modbus TCP mode#116 R/W Modbus TCP status Displaying current status of Modbus TCP mode#118 #117 R/W Modbus TCPdestination IP Setting up destination IP address for Modbus TCP transaction#119 R/W Modbus TCP data length Setting up the data length for Modbus TCP transaction#219 ~ #120 R/W Modbus TCP data buffer Data buffer of Modbus TCP for storing sending/receiving data#248 ~ #220 - Reserved#251 R Error code Displaying the errors. See table of error codes in the followingsection for more information.#255 ~ #252 - ReservedSymbols “R” refers to “able to read data by FROM instrcution”; “W” refers to “able to write data by TOinstrcution”.4.2 Explanations on CRCR#0: Model NameExplanations:1. Model code of DVPEN01-SL = H’4050.2. You can read the model code in the program to see if the I/O module exists.CR#1: Firmware VersionExplanations:The firmware version of DVPEN01-SL is displayed in hex, e.g. H’0100 indicates version V1.00.CR#2: Communication ModeExplanations:Bit No. Mode “0” “1”b0 Modbus TCP Disable Enableb1 Data exchange Disable Enable E-mail FunctionsCR#3 ~ 6: E-Mail Event 1 ~ 4 TriggerExplanations:When the CR is set as “1”, E-mail sending will be enabled. After the sending is completed, theCR will automatically be reset as “0”. Note: Please trigger by differential instructions.